INVERTER VFD004E21A

  


INVERTER VFD004E21A
INVERTER DELTA E SERIES
 VFD004E21A

Voltage Class 230V
Model Number  VFD004E21A
Max.Applicable Motor Output (kW) 0.4kW
Max.Applicable Motor Output (Hp) 0.5Hp
Rated Output Capacity (kVA) 1.0kVA
Rated Output Current (A) 2.5A
Maximum Output Voltage (V) 3 - Phase Proportional to Input Voltage
Output Frequency (Hz) 0.1 - 600 Hz
Carrier Frequency (kHz) 1-15kHz
Rated Input Current (A) 6.5A
Rated Input Voltage/Frequency 1 - Phase , 200-240V , 50/60Hz
Voltage Tolerance +/-10%(180-264V)
Frequency Tolerance +/-5%(47-63Hz)
Cooling Method Natural Cooling
Weight(kg) 1.1kg
   
Control System SPWM(Sinusoidal Pulse Width Modulation) Control(V/f  or sensorless vector control)
Frequency Setting Resolution  0.01Hz
Output Frequency Resolution 0.01Hz
Torque Characteristics Including the auto-torque/auto-slip compensation ; starting torque can be 150% at 3.0Hz
Overload Endurance 150% of rated current for 1 minute
Skip Frequency Three zones,setting range 0.1-600Hz
Accel/Decel Time 0.1 to 600 seconds (2 independent settings for Accel/Decel time)
Stall Prevention Level Setting 20 to 250% of rated Current
DC Braking Operation frequency 0.1-600.0Hz,output0-100% rated current, start time 0-60seconds,stop time 0-60seconds
Regenerated Braking Torque Approx.20% (up to 125% possible with optional brake resistor or externally mounted brake unit,1-15hp (0.75-11kW) models have brake chopper built-in 
V/F Pattern Adjustable V/f pattern
Frequency Setting Keypad Setting by arrow
Frequency Setting External Signal Potentiometer-5k/0.5W, 0 to +10VDC, 4 to 20mA, RS-485 interface; Multi-function Input 3 to 6 (15step,jog,up/down)
Operation Setting Signal Keypad set by RUN and STOP
Operation Setting Signal External Signal 2wires/3wires (FWD,REV,EF),JOG operation, RS-485 serial interface (MODBUS), programmable logic controller
Muti-Function Input Signal  Multi-step selection 0 to 15, Jog, accel/decel inhibit, 2accel/decel switches; counter, external Base Block(NC/NO), auxiliary motor control is invalid, ACI/AVI selections, driver reset, UP/DOWN key setting, sink/source(NPN/PNP)selection 
Muti-Function Output Indication AC drive operating, frequency attained, non-zero frequency, Base Block, fault indication,local/remote indication,auxiliary motor output, drive is ready, overheat alarm, emergency stop and status selections of input terminals(NC/NO)
Analog Output Signal Output frequency/current
Alarm Output Contact Contact will be ON when drive malfunctions (1 Form C/change-over contact or 1 open collector output)
Operation Functions Built-in PLC, AVR, accel/decel S-Curve, over-voltage/over-current stall prevention, 5fault records, reverse inhibition, momentary power loss restart, DC braking, auto torque/slip compensation, auto tuning, adjustable carrier frequency, output frequency limits, parameter lock/reset, vector control, PID control, external counter, MODBUS communication, abnormal reset, abnormal restart, power-saving, sleep/wake function, fan control, 1st/2nd frequency source selection, 1st/2nd frequencysource combination, NPN/PNP selection
Protection Functions Over voltage, over current, under voltage, under current, external fault, overload, ground fault, overheating, electronic thermal, IGBT short circuit, PTC
Display Keypad 6-key, 7-segment LED with 4-digit, 5status LEDs, master frequency, output frequency, output current, custom units, parameter values for setup and lock, faults, RUN, STOP, RESET, FWD/REV
Built-in EMI Filter For 230V 1-phase and 460V 3-phase models
Enclosure Rating IP20
Pollution Degree 2
Installation Location Altitude 1,000m or lower, keep from corrosive gasses, liquid and dust
Ambient Temperature -10C to 50C (40C for side-by-side mounting)
Storage/Transportation Temperature -20C to 60C
Ambient Humidity Below 90% RH (non-condensing)
Vibration 9.80665m/s2 (1G) less than 20Hz, 5.88m/s2(0.6G) at 20 to 50Hz
Approval Approval CE UL US

 

 

 
 
 
INVERTER VFD004E21A [   0.4kW 1/2HP 220V 1Phase ]
INVERTER VFD007E21A [ 0.75kW    1HP 220V 1Phase ]
INVERTER VFD015E21A [   1.5kW    2HP 220V 1Phase ]
INVERTER VFD022E21A [   2.2kW    3HP 220V 1Phase ]
--------------------------------------------------------------------
INVERTER VFD007E23A [ 0.75kW     1HP 220V 3Phase ]
INVERTER VFD015E23A [   1.5kW     2HP 220V 3Phase ]
INVERTER VFD022E23A [   2.2kW     3HP 220V 3Phase ]
INVERTER VFD037E23A [   3.7kW     5HP 220V 3Phase ]
INVERTER VFD055E23A [   5.5kW  7.5HP 220V 3Phase ]
INVERTER VFD075E23A [   7.5kW   10HP 220V 3Phase ]
INVERTER VFD110E23A [    11kW   15HP 220V 3Phase ]
INVERTER VFD150E23A [    15kW   20HP 220V 3Phase ]
--------------------------------------------------------------------
INVERTER VFD004E43A [   0.4kW 1/2HP 380V 3Phase ]
INVERTER VFD007E43A [ 0.75kW    1HP 380V 3Phase ]
INVERTER VFD015E43A [   1.5kW    2HP 380V 3Phase ]
INVERTER VFD022E43A [   2.2kW    3HP 380V 3Phase ]
INVERTER VFD037E43A [   3.7kW    5HP 380V 3Phase ]
INVERTER VFD055E43A [   5.5kW 7.5HP 380V 3Phase ]
INVERTER VFD075E43A [   7.5kW  10HP 380V 3Phase ]
INVERTER VFD110E43A [    11kW  15HP 380V 3Phase ]
INVERTER VFD150E43A [    15kW  20HP 380V 3Phase ]
INVERTER VFD185E43A [ 18.5kW  25HP 380V 3Phase ]
INVERTER VFD220E43A [    22kW  30HP 380V 3Phase ]